Complex Spine and Deformity Surgery
The Spine or backbone provides stability to the upper part of our body. It helps to hold the body upright. It consists of series of irregularly shaped bones appearing in a straight line. The spine has two gentle curves, when looked from the side and appears to be straight when viewed from the front. When these curves are exaggerated, pronounced problems can occur such as back pain, breathing difficulties, and fatigue.
There are different surgical approaches to repair the deformity, and the choice of the approach to the spine is based on the type of scoliosis, location of the curvature of the spine, ease of approach to the area of the curve and the preference of the surgeon.
Anterior approach – In this procedure surgeon will approach the spinal column from the front of the spine rather than through the back. The incision is made on the patient’s side, over the chest wall or lower down along the abdomen, depending on the part of the spine that requires correction. The lung is deflated and a rib is removed in order to reach the spine. After the exposure of the spinal column, the disc material between the vertebrae involved in the curve is removed. Screws are placed at each vertebral level involved in the curve, and these screws are attached to a single or double rod at each level. After instrumentation a fusion is performed, the bony surface between the vertebral bodies is roughened and bone graft is placed. A combination of compression along the rod, and rotation of the rod will correct the spine deformity. The incision is closed and dressed.
Posterior approach- It is the most traditional approach and the approach is made through the patient’s back while the patient lies on his or her stomach. The incision is made down the middle of the back. Hooks are attached to the back of the spine on the lamina, and screws are placed in the middle of the spine. After the placement of hooks and screws, a rod that is bent and contoured into a more normal alignment for the spine is attached and the correction is performed. After the final tightening, the incision is closed and dressed.
Anterior and posterior approach – This approach is used in cases where the curve is stiff and severe. The first approach to spinal column is made from the front. The incision is made on the patient’s side, over the chest wall or lower down along the abdomen. Disc material between the vertebrae is removed. This procedure requires removal of a rib, which is later used for bone grafting.
After the anterior procedure, the wound is closed and the patient is positioned for the posterior approach. The incision is made down the middle of the back. Hooks are attached to the back of the spine on the lamina, and screws are placed in the middle of the spine. After the placement of hooks and screws, a rod that is bent and contoured into a more normal alignment for the spine is attached and the correction is performed. After the final tightening, the incision is closed and dressed.
Video-assisted thoracoscopic surgery (VATS) –This is a minimally invasive technique performed using a small video camera. The patient lies on his or her side; four incisions of 1 inch are made on the side of the chest wall. A thoracoscope, a thin instrument with a tiny camera and light at its end, is inserted through one of the incision. The thoracoscope transfers images of the inside of the chest onto a video monitor, guiding the surgeon to perform the procedure. Retractor, suction and other surgical instruments are inserted through other incisions. Steps involved in the anterior approach are performed which involves intervertebral disc removal, bone grafting and instrumentation. Lung is deflated to gain access to the spine. The incisions are closed with an absorbable suture and the deflated lung is re-inflated.